| Step | | Procedure & Parts & Tools |
| 1 |
|
TURN KEY TO TURN OFF POWER TO VAC MOTOR
|
| 2 |
|
RAISE COVER ON MACHINE TO LOCATE THE VAC MOTOR
|
| 3 |
|
USE THE PROP BAR TO PROP COVER OPEN
|
| 4 |
|
WITH A T30 TORX, LOOSEN THE 2 SCREWS UNDER THE LID.
| Torx T30 |
|
|
| 5 |
|
PULL DOWN ON THE INSIDE COVER
|
| 6 |
|
IF YOUR MACHINE HAS A WHITE CONNECTOR BLOCK, REMOVE THE BLACK AND RED WIRES FROM THE WHITE CONNECTOR. CUT OFF BAD SECTION OF WIRE, THEN INSERT TRIMMED WIRES BACK INTO CONNECTOR BLOCK. IF YOUR MACHINE HAS SPADE ENDS, CUT TO REMOVE THE SPADE ENDS AND SPLICE NEW ENDS ON WIRES. IF LIMITED LENGTH OF WIRE, CUT OUT BAD SECTION AND SPLICE IN NEW WIRING USING WIRE NUTS AND ELECTRICAL TAPE.
| Screwdriver-flat tip |
|
|
| 7 |
|
REVERSE STEPS 2 THRU 6 TO REASSEMBLE MACHINE
|